 |
|
 STEP 1
Connect the R or RH wire to the RH terminal on the thermostat.
This connects the Heater Transformer to the thermostat.
 STEP 2
Connect the W wire to the W terminal on the thermostat.
This connects the heater control line to the thermostat.
Your Heater is now connected to the thermostat.
 STEP 3
OPTIONAL STEP
If you have the optional C-wire connect it now, this will supply aux power to your thermostat and eliminate the need to replace batteries.
Note: If the C-wire is not present the thermostat will function correctly. Be advised w/o the C-wire you must replace your thermostat's batteries regularly. If you would like to have the no battery replacement feature, you can install a C-wire from your system. See Installing A C-Wire.
You should now follow the remaining steps to verify you have correctly installed the unit.
STEP 4
You can now turn the power back on to your system.
Check HEAT mode by performing the following tasks:
- Set the mode switch to HEAT.
- Set the fan switch AUTO.
- Set the TEMP setting to its maximum. Allow the system 5 min to respond.
- Verify that heat is blowing from the system.
STEP 5
Your system should now be operational.
If your system is still not working correctly, please check all the steps once again.
We can start to check if there is problem in your system by following the Trouble Shooting procedure.
After you have rechecked your steps for installation, and trouble shot your system, you can contact via email.
Installation Complete!
Your system should now be operational.
If your system is still not working correctly, please check all the steps once again.
We can start to check if there is problem in your system by following the Trouble Shooting procedure.
After you have rechecked your steps for installation, and trouble shot your system, you can contact via email.
|
 |
|
|
|
|
